Chapter 5
V.42bis and MNP Command
This chapter explains ECDC commands and Extended commands, which are in addition to the basic modem commands listed in the previous chapter. Some commands have a factory default setting. Refer to your Getting Started manual for information on default settings.
5.1 | Maximum ECDC Block Size | [\A] | |
| \A0 | MNP block size 64 characters |
|
| \A1 | MNP block size 128 characters |
|
| \A2 | MNP block size 192 characters |
|
| \A3 | MNP block size 256 characters |
|
5.2 | Transmit Break | [\B] | |
\Bn Send n/10 seconds of line break to the modem (n = 0 ~ 9, default 3)
5.3 Set Break Control | [\K] |
\K0 Enter command mode, do not send a break signal to remote (To send a break after use the \B command)
\K1 Clear data buffer and send a break
\K2 Same as \K0
\K3 Immediately send a break
\K4 Same as \K0
\K5 Send a break in sequence with any data received from the port
Page: 25
