2.2.2.11IDE Connector (CN16)
The board provides 1 IDE channel, and is designed for one Enhanced Integrated Device Electronics hard disk drive or CDROM to the board's internal controller and one CF card. The IDE controller uses a PCI interface.
This advanced IDE controller supports faster data transfer, PIO mode 4,
How to connect the hard drive to CN16
1.Connect one end of the cable to CN16. Make sure that the red (or blue) wire corresponds to pin 1 on the connector, which is labeled on the board (on the right side).
2.Plug the other end of the cable into the Enhanced IDE hard drive, with pin 1 on the cable corresponding to pin 1 on the hard drive.
2.2.2.12PC-104 plus connector (CN17)
2.2.2.13COM port connector (CN19, CN41)
COM is the original, yet still common, name of the serial port interface on IBM PC- compatible
485(CN41).
2.2.2.14USB connectors (CN20, CN28, CN38)
The board provides up to 6* USB (Universal Serial Bus) ports. This gives complete Plug and Play, and hot attach/detach for up to 127 external devices. The USB inter- faces comply with USB specification Rev. 2.0 which supports 480Mbps transfer rate, and are fuse protected.
2.2.2.15Reset Button Connector (CN22)
CN22 is for system reset button. System reset clears any pending errors or events and bring a system to normal condition or initial state.
2.2.2.16Power button connector (CN23)
CN23 is 2 pin wafer type connector and support to turn on/off system.
2.2.2.17SIR connector (CN24)
The board can support IrDA function (optional by request). The function is shared from COM2 and data transfer rate is up to 115kbps.
2.2.2.18PS/2 keyboard and mouse connector (CN25)
2.2.2.19CF TYPE I/II connector (CN26)
CompactFlash (CF) is a mass storage device format used in portable electronic devices. For storage, CompactFlash typically uses flash memory in a standardized enclosure.
14 |