Advantech PCM-9588 First / Second / Third / Other Boot Drive, Boot Up Floppy Seek Disabled

!First / Second / Third / Other Boot Drive

Floppy	Assign this boot device priority to	Floppy.
LS120	Assign this boot device priority to	LS120.
Hard Disk	Assign this boot device priority to	Hard Disk.
CDROM	Assign this boot device priority to CDROM.
ZIP	Assign this boot device priority to	ZIP.
USB-FDD	Assign this boot device priority to	USB-FDD.
USB-ZIP	Assign this boot device priority to	USB-ZIP.
USB-CDROM	Assign this boot device priority to USB-CDROM.
USB-HDD	Assign this boot device priority to	USB-HDD.
LAN	Assign this boot device priority to	LAN.
Disabled	Disable this boot function.

!Boot Up Floppy Seek [Disabled]

When enabled, the BIOS will seek the floppy “A” drive one time.

!Boot Up NumLock Status [Disabled]

This item enables users to activate the Number Lock function upon system boot.

!Boot Up NumLock Status[Enabled]

This item enables users to activate the Number Lock function upon system boot

!Gate A20 Option [Fast]

This item enables users to switch A20 control by port 92 or not.

!Typematic Rate Setting

This item enables users to set the two typematic controls items. This field controls the speed at

–Typematic Rate (Chars/Sec)

This item controls the speed at which the system auto-repeats keystrokes. Eight settings are 6, 8, 10, 12, 15, 20, 24 and 30.

–Typematic Delay (Msec)

This item sets the keypress time interval before auto-repeat begins. The delay rate options are 250, 500, 750 and 1000.

!Security Option [Setup]

System	System requires password both for bootup and for access to the
	Setup page..
Setup	System requires password only for access to the Setup page, not for
	bootup. (Default value)

!APIC Mode [Enabled]

This item allows user to enabled of disabled "Advanced Programmable Interrupt Controller". APIC is implemented in the motherboard and must be supported by the operating system, and it extends the number of IRQ's available.

!MPS Version Control for OS [1.4]

This item sets the operating system multiprocessor support version.

!OS Select For DRAM > 64 M [Non-OS2]

Select OS2 only if system is running OS/2 operation system with greater than 64 MB of RAM on the system.

PCM-9588 User Manual 24