7.2.1 Installation for Windows 98/ME

1.If the Operating System's New Hardware Wizard prompts you with "New Hardware Found" for the "PCI Ethernet Controller", you

should click "Next" until "Finish" is clicked, without specifying location of the driver. You will see "PCI Ethernet Controller" in the Device Manager.

2.You can then install or update the NDIS driver with the "setup" or "setup -s" command:

a)setup: The InstallShield will prompt you with steps to install or upgrade the driver.

b)setup -s: The InstallShield will complete the installation or upgrade

without prompting you for any instructions.

You need to reboot the system immediately after the Install shield completes the installation/upgrade.

3.Do not click "Cancel" during New Hardware Wizard searches for the driver.

4.4. You can remove RTLSetup utility from Add/Remove Program Palette in Control Panel, the InstallShield will prompt you the steps

to remove the driver. After remove the driver, please restart the system immediately.

7.2.2 Installation for Windows 2000/XP

After finishing the Windows 2000/XP installation, the system will auto- matically detect the Ethernet hardware and install the Ethernet driver from the drivers database from Windows 2000, Windows XP when the system reboots.

It is recommended that you upgrade to the Intel driver provided with the CD. To upgrade to this driver, use this path : D:\PPC-V106\Lan\setup.exe

37

Chapter7

Page 49
Image 49
Advantech PPC-V106 user manual Installation for Windows 98/ME