Advantech UNO 2173A/AF

21 Chapter 3

Antenna

• Please select the necessary specification according to your application.

• One of the suggested antenna is 1750003222 (18 cm) which is a veri-

fied 802.11b/g 5dBi Dipole Antenna

Then follow the below steps for the installation:

1. Unscrew the bottom panel and open it.

2. Install the internal cable 1700001854 on the prepared rear panel

with the hole of antenna (1960032715N040 or 1960032715N020).

3. Replace the original rear panel with the panel assembled in step 2.

4. Plug the Wireless module onto the PCI Express mini card socket (

CN9)

5. Connect the internal cable with the module.

Contents

Main Page Page Page Page Page Contents Chapter 1 Overview ...........................................................2 Chapter 2 Hardware Functionality ................................10 Chapter 3 Initial Setup.....................................................18 Appendix A System Settings and Pin Assignments ..........24 Overview Chapter 1 Overview 1.1 Introduction 1.2 Hardware Specifications Page 1.3 Safety Precautions Page Page 1.5 Accessories Hardware Functionality Chapter 2 Hardware Functionality 2.1 Introduction 2.2 RS-232 Interface (COM1~COM2) 2.3 RS-422/485 Interface (UNO-2173AF) 2.3.1 RS-422/485 Selection 2.3.2 Automatic Data Flow Control Function for RS-485 2.3.3 Termination Resistor (SW3) 2.4 LAN: Ethernet Connector 2.5 Power Connector 2.6 PS/2 Keyboard and Mouse Connector 2.7 USB Connector 2.8 VGA Display Connector 2.9 Battery Backup SRAM (Reserved) 2.9.1 Lithium Battery Specification 2.10 Power Button / Power Management 2.11 Reset Button 2.12 HD Audio ( UNO-2173AF) 2.13 PCI Express Mini Card Socket 2.14 LVDS (UNO-2173AF) Page Initial Setup Chapter 3 Initial Setup 3.1 Inserting a CompactFlash Card 3.2 Chassis Grounding Page 3.5 Installing a Wireless LAN Card and Antenna Page Page Page Appendix A System Settings and Pin Assignments A.1 System I/O Address and Interrupt Assignment Table A.1: UNO-2173A/AF System I/O Ports Table A.2: UNO-2173A/AF Interrupt Assignment A.2 Board Connectors and Jumpers A.3 RS-232 Standard Serial Port (COM1~COM2) Table A.4: RS-232 standard serial port pin assignments A.4 RS-422/485 Serial Port (UNO-2173AF) A.5 Power Connector (PWR) Table A.5: RS-422/485 serial port pin assignments Table A.6: Power connector pin assignments Page A.8 VGA Display Connector Table A.9: VGA adaptor cable pin assignment A.9 LVDS and LVDS_PWR (UNO-2173AF) A.9.1 LVDS Table A.10: LVDS pin definitions A.9.2 LVDS Power Setting (CN17) A.9.3 LVDS_PWR (Backlight Control) Table A.11: CN17 Configuration Table A.12: LVDS_PWR pin definition A.10 Clear CMOS (CN3)