Installation

Unpacking

All transit bolts and packing must be removed before using the appliance.

Using a spanner, unscrew and remove the rear right-hand bolt and lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor.

Remove the polystyrene block from the bottom of the machine and release the two plastic bags by removing the adhesive strip.

2 1

Carefully remove

the right-hand bag (1) then the left-hand bag (2) by pulling them towards the centre of the machine.

Set the machine upright and remove the two remaining bolts from the back.

Pull out the three plastic spacers from the holes into which the bolts were fitted.

Plug the open holes with the plugs which you will find at the back of the appliance.

You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again.

82

Page 40
Image 40
AEG 135 EL manual Installation, Unpacking