Opening the door after the programme has started | AEG 135 EL

Description of the appliance

Warning! If the programme selector knob is turned first to CANCEL (IPTAL) and then to the new programme, the programme which is run- ning is cancelled, the water is emptied out and the machine re-starts from water filling. To simply modify the programme which is running, turn the programme selector knob to the desired position (avoiding the CANCEL position): when the START/PAUSE (START ARA VERME) button is pressed again, the machine restarts with the newly selected pro- gramme from the point at which it was interrupted.

Opening the door after the programme has started

The door can only be opened before the machine starts the heating phase (within the first 15, 10 or 5 minutes, depending on the pro- gramme selected - see paragraph above) and during the rinse phase.

Set the machine to PAUSE (by pressing the START/PAUSE - START ARA VERME button).

If the door does not open, this means that the machine is already heat- ing, or that the water level is above the bottom edge of the door.

This prevents large quantities of water from gushing out when the door is opened.

The door cannot be opened until the pilot light has gone out.

58

Image 16

AEG 135 EL manual Opening the door after the programme has started

Contents

Lavamat 135 EL Dear customer Contents Page Safety instructions General notesPositioning, connection, starting up Follow the instructions for positioning and connection Child safety Proper use Packaging materials DiscardingMachine Tips for environmental protection Main features of your washing machine Description of the appliance Front view Control panel Mains on lightON/OFF button Açma Kapama Buttons and corresponding functions Display Delay Start button Geciktirme TU‚UDisplay shows the following information Quick Wash button Kisa Yikama Prewash button ÖN YikamaExtra Rinse button EK Durulama Anticrease button stop with water in drum START/PAUSE button Start ARA Verme Spin Speed button SikmaStart Pause Programme phase indicator Cancelling a programmeSymbols on the programme selector Programme selector Opening the door after the programme has started Detergent and additive dispenser drawer Before the first wash Preparing the wash cycle Sorting out and preparing the laundry Types of fabric and care labels WhitesColoureds Coloureds 40 Delicates 40 Woollens and particularly delicate items Detergents and additives How to wash Switching the machine onLoad the laundry Add detergent and additive Selection of the desired wash programme Selection of the spin speedSpin Speed Sikma button the corre Sponding light comes on Corresponding light comes on Selection of the Delay Start option Geciktirme TU‚U Starting the programme At the end of the programme Wash programmes Programme chartWash Temp Fabrics Additional Max Consumption Type Special programmesMax Consumption Laundry Cleaning and maintenance Periodical cleaning BodyworkAfter each wash Detergent dispenser drawer Drain filter Water inlet filter Frost precautions Emergency emptying out Problem Possible cause Solution TroubleshootingSomething not working? Problem Possible cause Solution Feet have not been Problem Possible cause Solution Unsatisfactory washing results If grey stains remain on the laundryFoam is still visible even after the last rinse White residue is left on the laundry Technical data This appliance complies with the following EC directives Service Instructions for installation and electrical connection Safety instructions Dimensions of the appliance Rear view Installation Unpacking Levelling PositioningBefore placing it on small tiles, apply a rubber coating Electrical connection Permanent connectionDirectly into a Not more than 90 cm End Water drainage Water inletEnd of the drain hose can be positioned in three ways