AEG PV 2000 operating instructions Low DC Bus

27

Inverter Failure

	1.	Check the open PV voltage, see if it is greater than or too close
PV over Voltage		to 450VDC
	2.	If PV voltage is less than 450VDC, and the problem still occurs,
		please call local service
	1.	Disconnect PV (+) or PV (-) from the input, restart the PV-
Consistent Fault		Inverter
	2.	If it does not work, call service
	1.	The internal temperature is higher than specified normal value
Over Temperature	2.	Find a way to reduce the ambient temperature.
	3. Or move the inverter to a cooler environment
	4.	If it is not effective, call local service

Relay Failure
DC INJ High
EEPROM Failure
	1. Disconnect ALL PV (+) or PV (-)
SCI Failure
	2. Wait for few seconds
High DC Bus
	3. After the LCD switches off, reconnect and check again
Low DC Bus
	4. If the message reappears call your local service
Ref 2.5V Fault
DC Sensor Fault
GFCI Failure

•If there is no display on the panel, please check PV-input connections.

If the voltage is higher than 150V, call your local service.

•During periods of little or no sunlight, the PV-Inverter may continuously start up and shut down. This is due to insufficient power generated to operate the control circuits.