AEG PV 2000 operating instructions Inverter Status, Display information

21

6. Inverter Status

Protect PV is designed to be user-friendly; therefore, the status of the Inverter can be easily understood by reading the information shown on the front panel display. All possible messages are shown in the following table.

Display information

Operating conditions	Message	Description
Normal Working Status
Power off	No display	PV inverter is totally
		shutdown, VPV <=70V
Standby	STANDBY	90V< Input voltage < =100V
		Input voltage range 100~150V
		during start-up. After PV
Initialization & waiting	READY	voltage is higher than 100V,
		inverter is waiting for feeding
		to grid
		When PV voltage> 150V,
Check grid	CHECKINGxxxs	inverter is checking feeding
		conditions
		Inverter is feeding power. After 10
Feeding grid, MPPT	GRID CONNECTED	seconds of this display, LED will show
		wattage.
FLASH	FLASH	FLASH-firmware
Today energy	Etoday=xxx.xxkWh	Total energy to has been fed
		to grid since today
Monitoring parameters
Instantaneous	Pac=xxx.xW	The real time output power in xxxx W
Output power
Accumulated energy		Total energy to has been fed
	Etot=xxxxxxkWh	to grid since inverter was
information
		installed
Grid voltage	Vac=xxx.xV	Grid voltage in xxx.x VAC
Grid frequency	Fac=xx.xHz	Grid frequency in xx.x Hz