AEG 48380 manual The machine is vibrating or, the machine see unpacking section

User information

Symptom	Cause
The machine is vibrating or	•	not all the packing was removed from
noisy :		the machine (see unpacking section),
	•	the washing machine is not leveled
		and properly packed,
	•	the washing machine is too close to
		the wall or furniture,
	• the washing is not well distributed in
		the drum,
	• the load is not sufficient.
The washing cycle is much	•	the water inlet is blocked (No inco-
too long :		ming water. Check tape & hose)
	• there was a power supply failure or the
		water was cut off,
	•	the motor temperature safety device
		tripped,
	•	the water inlet temperature is lower
		than normal,
	• the foam detection safety system trip-
		ped (too much detergent) and the
		washing machine evacuated the foam,
	• the anti-unbalance mass safety device
		tripped, an additional phase was
		added to distribute the washing in the
		drum better.
The washing machine stops	•	the water or electricity supply is
during a washing cycle :		defective,
	• a rinse hold was programmed.
The cover does not open	•	the «IMMEDIATE OPENING»* light is off,
during the cycle :	•	the temperature of the washing water
		is too high,
	•	the cover cannot open until 1 to 2
		minutes after the washing machine
		has stopped*.

34