Operating Instructions
Changing the programme after the start delay has been set:
As long as the programme has not started, you can still change the pro- gramme set by pressing a programme button.
0 1. Press the button for the new programme and hold it down.
First the indicator for the programme that has just been selected will flash.
After several seconds only the indicator for the new programme will be flashing.
2.Release the programme button.
The newly selected programme will start automatically following a countdown of the hours set.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes in the upper and/or lower basket, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.
Switching Off the Dishwasher
Switch the dishwasher off when the
0 1. Press the ON/OFF button. The ON/OFF button indicator extinguishes.
1 | Hot steam may escape from the appliance when opening the door |
| immediately after the end of the programme. |
2.Open the door carefully, as steam may escape.
| Emptying the Dishwasher |
3 | • The dishes should be allowed to cool down before removing them |
| from the appliance, as hot dishes can be sensitive to knocks. |
• Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.
• First empty the lower basket, and then the upper basket. This will avoid any water that may be remaining in the upper basket, dripping onto the dishes in the lower basket and leaving water marks.
28
