Denon ADV-M51 manual Using the Timer, Setting the clock 12-hour display, Before setting the timer

ENGLISH

18

USING THE TIMER

2Timer and system operations are possible once the setup procedure has been completed.

(1) Setting the clock (12-hour display)

Example: Setting the current time to “7:30 p.m.”

	4,6	2,3,5,7		5	Press the MENU/SET button.
DVD SURROUND RECEIVER ADV-M51	SURROUND / SELECT				A d j	P M 7 : 00
	PUSH - PARAM.
			- +
	MENU / SET		BAND
	TONE / SDB		VOLUME
	FUNCTION

ON / STANDBY

PHONES

MENU / SET

Main unit

1

1 Turn on the power.

ON / STANDBY

Main unit

2 Press the MENU/SET button to display “Time”.

T i m e A M 1 2 : 00 MENU / SET

Main unit

•If the time has not yet been set or if there has been a power shortage, the time display flashes.

•If the time has been set, the current time is displayed.

3	Press the MENU/SET button and hold it in for over 2 seconds.
	• The hours position flashes.
	A d j	A M 1 2	: 00	MENU / SET
				Main unit
4	Turn the SURROUND/SELECT knob to set the hours.
	A d j	P M 7	: 00	SURROUND / SELECT
				PUSH - PARAM.

6	Turn the SURROUND/SELECT knob to move to the minutes
	position.
		A d j	P M 7 : 30	SURROUND / SELECT
				PUSH - PARAM.
				Main unit
7	Press the MENU/SET button at the sound of a time signal,
	etc.

•The “30” in the minutes place stops flashing and the current time is displayed.

T i m e P M 7 : 3 0 MENU / SET

Main unit

To check the current time when the regular display is displayed, press the MENU/SET button once. The current time remains displayed until some other operation is performed.

The time can be displayed by pressing the MENU/SET button when the power is in the standby mode. (When this is done, the set is no longer in the low power consumption standby mode.) When pressed twice while the time is displayed, the display turns off and the set is put back in the low power consumption standby mode.

The current time can also be set when the power is in the standby mode by pressing the MENU/SET button to display the time then performing steps 3 to 7.

The clock runs by synchronizing with the power supply frequency. The time may be off by 2 to 3 minutes per month. If so, reset the time.

Main unit

Before setting the timer

2Be sure to set the current time. If the current time is not set, the timer standby indicator does not light and the timer will not function.

2Be sure to preset the broadcast station before setting the timer. (See page 60.).

2Everyday timer: The power is switched on and off (standby) once at the same time each day.

Once timer: The power is switched on and off (standby) at the specified time once only.

Sleep timer: The power can be set to turn off in 120 minutes, 90 minutes, or between 60 and 10 minutes in 10 minute steps.

2If the times set for the everyday timer, once timer and sleep timer overlap, the sleep timer has priority. The once time has priority if the everyday timer and once timer times overlap.

2It is not possible to set the timer start and stop times to the same time.

81