Denon ADV-M51 English, DOLBY VS Dolby Virtual Speaker mode, D.COMP. Dynamic range compression

6	Select and	set	the surround
	parameters.
	(On the remote control unit, use the
	0, 1 cursor buttons to set the
	parameters.)
	If nothing is done for 6 seconds
	from when the parameter is
	displayed,	the	normal display
	reappears.

BSetting the DOLBY VS mode

SURROUND / SELECT

PUSH - PARAM.

Main unit

ENGLISH

Surround parameters (1)

DOLBY VS (Dolby Virtual Speaker mode)

•REF (Reference mode) This is the standard mode.

•WIDE (Wide mode)

This mode expands the front channel sound field.

D.COMP. (Dynamic range compression)

• This parameter adjusts the dynamic range of the Dolby

Digital or DTS sound. When listening with the volume

turned relatively low, at night for example, set this to the

V S R E F W I DE

The selected mode flashes.

The mode is not displayed if it cannot be selected.

BD.COMP. setting

D . C O M P . O FF

OFF LOW MID HI

,/

BSetting the LFE level

L F E 0 dB

-10 ...-5 ...0

, /

The LFE level can be adjusted in steps of 1 dB between

–10 dB and 0 dB.

BDEFAULT setting

D EFAULT Y/N

YES NO

,/

When “YES” is selected, the settings are restored to the factory defaults.

When the surround parameters are displayed, use the • and ª cursor buttons on the remote control unit to switch to previous or following items.

Once the surround parameters have been set, stop operating the buttons. After several seconds, the normal display reappears and the settings are automatically entered.

“HI” side to lower the peak of the sound and amplify the
quieter sounds, narrowing the dynamic range and making
the sound easier to listen to. Set to “OFF” to turn this
function off.
OFF	LOW	MID	HI

Wide Narrow

Dynamic range

•With DTS sources, only displayed for sources compatible with dynamic range compression.

LFE (Low Frequency Effect):

•Program source and adjustment range

1. Dolby Digital :	–10 dB to 0 dB
2. DTS Surround :	–10 dB to 0 dB

•When Dolby Digital encoded software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct Dolby Digital playback.

•When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback.

•When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to –10 dB for correct DTS playback.

51