Denon ADV-M51, D-M51DVS, ADVM51 manual Before Using, DVD Surround Receiver

1 BEFORE USING

Pay attention to the following before using this unit:

•Moving the set

To prevent short circuits or damaged wires in the connection cords, always unplug the power cord and disconnect the connection cords between all other audio components when moving the set.

•Before turning the power switch on

Check once again that all connections are proper and that there are not problems with the connection cords. Always set the power switch to the standby position before connecting and disconnecting connection cords.

•Store this instructions in a safe place.

After reading, store this instructions along with the warranty in a safe place.

•Note that the illustrations in this instructions may differ from the actual set for explanation purposes.

2CAUTIONS ON INSTALLATION

(1)DVD SURROUND RECEIVER

Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV.

If this happens, take the following steps:

•Install this unit as far as possible from the tuner or TV.

•Set the antenna wires from the tuner or TV away from this unit’s power cord and input/output connection cords.

•Noise or disturbance tends to occur particularly when using indoor antennas or 300 Ω /ohms feeder wires. We recommend using outdoor antennas and 75 Ω /ohms coaxial cables.

(2) SPEAKER SYSTEM (D-M51DVS only)

2SC-A3L

The quality of the sound produced from the speaker system is affected by the size and type (Japanese or Western) of the room, as well as by the method of installation. Consider the points listed below before installing the speaker system.

•Note that placing the speaker system on the same stand or shelf as a record player may result in howling.

•If there is a wall, glass door, etc., directly in front of or behind the speaker system, cover the wall or door with a thick curtain to prevent resonance and reflection.

•The SC-A3L speaker systems are of the low-leakage-flux type and can be used near televisions, but depending on the TV there may be color blotching on the picture. If this happens, turn off the TV’s power, wait 15 to 30 minutes, then turn the TV’s power back on. The TV’s automatic degaussing circuit should reduce the blotching on the picture. If blotching persists, move the speaker further away.

•When placing the satellite speaker system (SC-A3L) on a stand, etc., stick the included anti-slip pads (cork, approximately 2 mm thick) at the four corners of the bottom surface. (Refer to the illustration below.)

•When mounting the satellite speaker system (SC-A3L) on a stand or bracket, M5 nuts are inserted into the bottom of the satellite speaker system (SC-A3L) at intervals of 60 mm. When mounting, following the instructions in the manual included with the speaker stand or ceiling mount bracket, and be sure to install properly and securely.

•When the satellite speaker system (SC-A3L) is mounted on a ceiling mount bracket, it is turned upside down due to the installation angle. The Denon mark is also turned upside down, so detach the speaker net and reattach it in the opposite direction.

ENGLISH

2DSW-3L

•Note that placing the active subwoofer on the same stand or shelf as a record player may result in howling.

•The DSW-3L active subwoofer is a Lowleakage-Flux type speaker system and can be used near televisions, but depending on the TV there may be color blotching on the picture. If this happens, turn off the TV’s power, move the TV and subwoofer a little apart, wait 15 to 30 minutes, then turn the TV’s power back on. The TV’s automatic degaussing circuit should reduce the blotching on the picture. If blotching persists, move the subwoofer and TV further away from each other.

•Install on a firm, flat floor to prevent accidents due to toppling down.

•Do not place a record player, CD player or other AV device on top of the subwoofer.

For heat dispersal, leave at least 10 cm/4 inch of space between the top, back and sides of this unit and the wall or other components.

10 cm/4 inch or more

B

10 cm/4 inch or more

Wall

10cm/4 inch or more

Wall

[ Satellite speaker system (illustration of bottom of SC-A3L) ]

Stick the anti-slip pads (cork, approximately 2 mm thick) here.

Speaker stand/speaker bracket mount screw holes

Stick the anti-slip pads (cork, approximately 2 mm thick) here.

CAUTION:

•To ensure safety, do not place any objects on top or lean objects against the speaker system.

•The speaker may topple down or fall if force is applied to the sides. Be particularly careful to avoid this, as this could cause injury or other serious accidents.

5