Denon ADV-M51 manual Last Function Memory, Initialization Of The Microprocessor, English, Notes

ENGLISH

21

LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides memory storage when the power switch is off and with the power cord disconnected.

22

INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1	Press the power button to set the				2	2
	standby mode, then unplug the set’s	ON / STANDBY	Red
	power cord from the wall power outlet.		B DVD SURROUND RECEIVER ADV-M51	PUSH - PARAM.
				SURROUND / SELECT
					- +
				MENU / SET		BAND
				TONE / SDB	VOLUME
				FUNCTION
			ON / STANDBY
				PHONES

2	Hold the following PLAY/PAUSE (1/3) button and STOP (2)
	button after 30 second, and plug the AC cord into the outlet.
3	Check that the entire display is flashing with an interval of
	about 1 second, and release your fingers from the 2 buttons

and the microprocessor will be initialized.

1

NOTES:

•If step 3 does not work, start over from step 1.

•If the microprocessor is reset, all the buttons and the setup settings are reset to the factory default values.

105