Denon ADV-M51, D-M51DVS, ADVM51 English, Input signal display, Input mode when playing CD sources

Either turn the SURROUND/SELECT dial or press the

3 SURROUND button on the remote control unit to select the surround mode.

SURROUND / SELECT	SURROUND
PUSH - PARAM.

Main unit Remote control unit

•The function switches as shown below.

•The function only changes in the “Æ” direction when operated from the remote control unit.

DOLBY VS STEREO DIRECT ROCK ARENA

JAZZ CLUB VIDEO GAME DOLBY VS

ENGLISH

Input mode display

Lit

• In the AUTO mode

One of these lights, depending on the input signal.

• In the DIGITAL PCM mode

• In the DIGITAL DTS mode

• In the ANALOG mode

4	Start playback on the selected component.
	• For operating instructions, refer to the component’s
	manual.
5	Either turn the MASTER VOLUME dial on the main unit or
	use the VOLUME buttons on the remote control unit to
	adjust the volume.

M.VOLUME -20	The volume level is displayed
	on the display.
	+
	VOLUME
	-

Main unit Remote control unit

•The volume can be adjusted within the range –60 to 0 to +18 dB. Note that depending on the input signal, surround mode, speaker settings and channel level setting, it may not be possible to adjust the volume up to +18 dB.

2To check the currently playing program source, etc. Press the MENU/SET button. Display “STATUS” then turn the SURROUND/SELECT control.

MENU / SET	SURROUND / SELECT	STATUS
	PUSH - PARAM.

Main unit Main unit Remote control unit

To perform this operation on the remote control unit, press the STATUS button.

The current program source and surround settings are shown on the display each time the button is pressed or turned. (When the function is set to DVD, the information is also displayed on the TV screen.)

Input signal display

• DOLBY DIGITAL

• DTS

• PCM

•“DIG” lights when digital signals are input properly. If “DIG” is flashing, check whether the connections are proper and whether the input component’s power is on.

Input mode when playing CD sources

•When playing CDs containing recordings of live concerts, etc., in the “AUTO” mode, the sound may be slightly broken at the beginning. If this happens, switch to the “PCM” mode.

Input mode when playing DTS sources

•If DTS-compatible CDs are played in the “PCM” mode, noise is output because DTS playback is not possible.

To play a DTS-compatible source, be sure to set the input mode to “AUTO” or “DTS”.

•Noise may be generated at the beginning of playback and while searching during DTS playback in the AUTO mode. If so, play in the DTS mode.

45