Operating Instructions
...Error messages are displayed.
If any of the indicators in the control panel, as listed in the table below, are flashing or are illuminated, you can probably rectify the fault your- self.
| Malfunction | Possible cause | Remedy |
|
| The tap is blocked or furred | Clean the tap |
|
| with | |
|
|
| |
|
| The tap is turned off. | Turn the tap on. |
|
| The filter (where present) in |
|
|
| the threaded hose fitting at | Clean the filter in the |
|
| the water inlet valve is | threaded hose fitting. |
| The programme indicator | blocked. |
|
| for the selected programme |
|
|
|
| Press the button for the | |
| is flashing: error code Å 10 |
| |
|
| selected programme, | |
| is displayed in the |
| |
|
| then cancel the pro- | |
| play: there is no water run- |
| |
| Filters in the base of the | gramme by pressing | |
| ning into the dishwasher. | ||
| washing compartment are | RESET (see chapter: | |
|
| ||
|
| blocked. | “Starting a programme”); |
|
|
| clean out the filters (see |
|
|
| chapter: “Cleaning the |
|
|
| filters”). |
|
| The water inlet hose has not | Check hose installation. |
|
| been correctly laid. |
|
| The programme indicator | The siphon is blocked. | Clean out siphon. |
| for the selected programme |
|
|
| is flashing, error code Å 20 | The water drain hose has | Check hose installation. |
| is displayed in the | not been correctly laid. | |
|
| ||
| play. |
|
|
| Error code Å 30 is displayed | The leak prevention system | Turn off the tap and |
| contact customer serv- | ||
| in the | has been triggered. | |
| ice. | ||
|
|
| |
| After rectifying an Å 10 or Å 20 error, press the button for the pro- | ||
| gramme that has been started. The programme will continue. | ||
| If the fault is displayed again, please contact customer service. | ||
3 | For all other errors displayed, please contact customer service, stating | ||
| the error code. (See chapter “Customer Service”). |
|
31