Error messages
Display message Cause/solution
Busy RThe called unit is in use.
ROther units are in use and the system is busy. Try again later.
RPrivacy mode is on for the call you tried to join (page 17).
RThe handset you are using is too far from the base unit. Move
closer and try again.
Check tel line 1
Check tel line 2
RThe supplied telephone line cord has not been connected yet or
not connected properly. Check the connections (page 8).
RIf you use the unit as a single-line telephone only, erase the
message as follows:
To erase “Check tel line 1”, press MMENUN. a #189
To erase “Check tel line 2”, press MMENUN. a #190
When a power failure occurs, the message is displayed again.
Erase again as above.
Error!! RRecording was too short. Try again.
Failed RPhonebook copy failed (page 25). Confirm the other unit (the
receiver) is in standby mode and try again.
Incomplete RPhonebook copy is incomplete. The receiver’s phonebook
memory is full. Erase the unwanted phonebook entries (page 24)
from the other unit (the receiver) and try again.
Memory full RThe phonebook memory is full. Erase unwanted entries (page 24).
RMessage memory is full. Erase unwanted messages (page 36,
37).
Messages full RMessage memory is full. Erase unwanted messages (page 36,
37).
No link to base.
Reconnect AC adaptor.
RThe handset has lost communication with the base unit. Move
closer to the base unit and try again.
RUnplug the base unit’s AC adaptor to reset the unit. Reconnect
the adaptor and try again.
RThe handset’s registration may have been canceled. Re-register
the handset (page 31).
Use rechargeable
battery.
RA wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4,6.
You must first
subscribe to Caller ID.
RYou must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
For assistance, please visit http://www.panasonic.com/help 45
Useful Information