Interrupting a programme/Adding washing
Interrupting a programme
•A washing programme can be interrupted at any time by pressing the
button (START/PAUSE) and then
button (START/PAUSE) again.
•To stop the washing machine before the programme has ended, turn the programme knob to 
(OFF). Important: Be careful if there is water in the appliance!
Adding washing
It is possible to add washing, as long as the 
(DOOR) light is lit green.
1.Press the 
button (START/PAUSE). The door can be opened.
2.Close the door and press the 
button (START/PAUSE) again. The programme will continue.
End of the wash cycle/Removing the washing
When the programme has finished, 
(END) will illuminate on the pro- gramme progress display. The door can be opened as soon as the 
in- dicator (DOOR) is lit green.
1.Open the door and remove the washing.
2.Turn the programme knob to 
(OFF).
3.Close the water tap.
4.When you have finished washing, pull out the detergent drawer a little to let it to dry out. Keep the door very slightly open so that the washing machine can air.
If 
(RINSE HOLD) has been selected:
Following a rinse hold 
(END) will be lit on the programme progress display.
The water must first be drained off:
–Either turn the programme knob to 
(OFF), then to 
(DRAIN) and
press the 
button (START/PAUSE) (the water will be drained without spinning),
–turn the programme knob to 
(OFF) and then to 
(SPIN). Change
the spin speed, if necessary, and press the 
button (START/ PAUSE) (the water will be drained and the washing spun).
16
