Positioning, Fill the smaller | AEG 60895, 62895 instruction

Installation

Open the porthole, take out the inlet hose from the drum and remove the polystyrene block fitted with the adhesive tape on the door seal.

HEC0010

Fill the smaller

upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet.

Important!

All the different plug caps are supplied with the appliance in the plastic bag containing the instruction booklet.

Connect the water inlet hose as described under the paragraph “Water inlet”.

HEC0005

P0002

Positioning

Install the machine on a flat hard floor.

Make sure that air circulation around the machine is not impeded by carpets, rugs etc.

•Before placing it on small tiles, apply a rubber coating.

•Never try to correct any unevenness in the floor by putting pieces of wood, cardboard or similar materials under the machine.

•If it is impossible to avoid positioning the machine next to a gas cooker or coal-burning stove, an insulating panel (85x57 cm) covered with aluminium foil on the side facing the cooker or stove, must be inserted between the two appliances;

•The machine must not be installed in rooms where the temperature can drop below 0.

•The water inlet hose and the drain hose must not be kinked.

•Please ensure that when the appliance is installed, it is easily accessi- ble for the engineer in the event of a breakdown.

83

Image 41

AEG 60895, 62895 manual Positioning, Fill the smaller

Contents

Lavamat L 60895 Dear customer Contents Programme charts wash and special programmes Page General safety Safety instructionsPositioning, connection, starting up Follow the instructions for positioning and connection Proper use Child safety Tips for environmental protection DisposalPackaging materials Machine Main features of your washing machine Front view Description of the appliance Programme selector dial Control panel START/PAUSE button START/PAUSA Delay Start button Preselección To be used for heavily soiled laundry Programme Option buttons Programme progress display Display Tiempo Altering a programme which is running Cancelling a programmeAltering an option which is running Opening the door after the programme has started Before the first wash Detergent dispenser drawer Sorting out and preparing the laundry Preparing the wash cycle Sort of laundry Approximate Dry weights Weight of laundryTypes of fabric and care labels Cotton Delicates Detergents and additives Add detergent and additives How to washLoad the laundry Select the spin speed or Rinse Hold option Select the desired wash programmeSelect the desired options Selection of the Extra Rinse option Select the Delay Start option Display Starting the programme At the end of the programme 40-30 Programme chartWash programmes for cottons Functions Wash Temp Fabrics Additional Max Consumption KWh Water lt Special programmesConsumption Energy Tion Periodical cleaning Exterior Cleaning and maintenanceAfter each wash Detergent dispenser drawer Drain pump Door seal Screw the pump fully Close the pump door Water inlet filterEmergency emptying out Frost precautions Something not working? TroubleshootingProblem Possible cause Solution Possible cause Solution Problem Distributed Problem Possible cause If grey stains remain on the laundry Unsatisfactory washing resultsFoam is still visible even after the last rinse White residue is left on the laundry This appliance complies with the following EC directives Technical dataWater pressure 05 0.8 MPa Service Safety instructions for the installer Instructions for installation and electrical connection Unpacking InstallationSix smaller bolts C Remove the bracket D. Tighten up the six smaller bolts C Fill the smaller Positioning MPa 0.5 bar is required for safe operation of the appliance LevellingWater inlet End of the drain hose can be positioned in three ways Water drainage Connect the machine to an earthed socket Electrical connectionPermanent connection Page From the Electrolux Group. The world’s No choice Salvo modificaciones