Instructions for use
Washing Cycle Ended/Remove Washing
After a washing program has ended, END (EINDE, FIN) lights up on the program sequence display.
If you selected RINSE HOLD (GEEN CENTR., SANS ESSOR.), the indicator next to the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
–Press either the button START/PAUSE (START/PAUZE, MARCHE/ PAUSE) (water is pumped off and the washing is spun according to the program which has just run; after pressing the button START/ PAUSE (START/PAUZE, MARCHE/PAUSE) again, the spin speed can also still be changed during spinning),
or
–turn the program selector to PUMP (POMPEN, VINDAGE) and press the button START/PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off without spinning)
or
–turn the program selector to SPIN (CENTRIFUG., ESSORAGE) or SHORT SPIN (KORT CENTRIFUG., ESSOR. DELICAT) and press the button
START/ PAUSE (START/PAUZE, MARCHE/PAUSE) (water is pumped off and the washing is spun or gently spun).
After the end of this program step, the indicator END (EINDE, FIN) lights up.
2.Open the filling door.
As soon as the indicator DOOR (DEUR, PORTE) lights up green, the fill- ing door can be opened.
3.Remove the washing.
4.Turn the program selector to OFF (UIT, ARRET).
5.After washing, pull out the washing detergent drawer slightly so that it can dry out. Only lean the door against the washing machine so that the latter can air out.
3 | If the display OVER DOSING (OVERDOS., SURDOSAGE) | OVERDOS. |
lights up, too much washing detergent was used in the | SURDOSAGE | |
| washing program just ended. During the next wash, pay |
|
attention to the dosing information of the washing detergent manufacturer and pay attention to the filling quantity!
Attention! If the washing machine is not used for a long time: Close the water tap and disconnect the washing machine from the electricity mains. (The Aqua Control water protection does not function if the power supply is interrupted).
27
