AEG 80850 I manual work surface must be re-mounted

Installation and Connection Instructions

•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:

–Unscrew the screws (1) from the elbows on the back side.

–Slide the work surface approx. 1cm to the rear (2) , lift at the front (3) and remove.

–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear

(5).

4

5

1	If the dishwasher is later used as a free-standing appliance, the original
	work surface must be re-mounted.
3 The plinth on free-standing appliances is not adjustable.
	• Free-standing appliances can be
	fitted with a décor panel to match
	the facings of other kitchen equip-
	ment. The décor panels must be
	obtained from the kitchen manu-
	facturer. A décor frame is necessary
	for installation, and can be
	obtained as an accessory from the
	dealer if not included in the scope
	of delivery.

• Decor panel dimensions:

– Height 590 mm

–Width 581 mm

–Clamp thickness: max. 4 mm

•To ensure that thin decor panels do not flex or distort, attach them to the door of the appliance using double sided adhesive tape.

39