Operating Instructions
Changing the start delay:
As long as the wash programme has not started, you can still change the start delay set by pressing the DELAY TIMER button.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes in the upper and/or lower rack, an intelligent electronic system adjusts the amount of water and the duration of the wash programme to the number of dishes. By this means it is possible to wash only a few dishes quickly and economically. At half load (6 place settings), up to 2 litres of water and 0.2 kWh of electricity are saved.
Switching Off the Dishwasher
Only switch the dishwasher off when the
If the signal tone for the end of the washing programme is enabled, a continuous tone indicates the end of the programme for 10 seconds. If the dishwasher is not switched off, the continuous tone is repeated twice after a few minutes.
0 1. Press the ON/OFF switch. All indicators go out.
1 | Hot steam may escape if the door is opened immediately after the end |
| of the programme. Therefore: |
2.Open the door carefully.
| Emptying the Dishwasher |
3 | • Hot dishes are sensitive to knocks. The dishes should therefore be |
| allowed to cool down before removing them from the appliance. |
• Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down.
• Empty the lower rack first, then the upper rack. In this way you will avoid any water left on the upper rack dripping onto the dishes in the lower rack and causing water spots.
28
