Instructions for use
38
Washing is not spun.
Remaining water is vis-
iblein the drum.
Error code (2 appears.
There is a kink n the drainage
hose. Remove kink.
Maximum pump height
(emptying height 1m from
base surface of the appli-
ance) is exceeded.
Refer to the customer
service. For pumping heights
over 1m, they have a supple-
mentary set as special spares
available.
Water pump is blocked.
Switch off appliance and pull
out electric plug. Clean wa-
ter pump.
At the siphon connection: Si-
phon is blocked. Clean siphon.
Door cannot be opened
when appliance is
switched on.
Door is locked for safety rea-
sons (display DOOR/LIGHT is
Off).
Wait till display DOOR/LIGHT
(DEUR/LICHT, PORTE/ECLAIR.)
lights up green.
Programme security is
switched On.
Cancel programme security
(see section „Programme se-
curity“).
Detergent remain s
form inthe washing
powder/liquid drawer.
Water tap is not fully
opened. Open water tap fully.
Filter in the socket of the in-
flow hose at the water tap or
the appliance is blocked.
Close water tap. Disconnect
inflow pipe from water tap
and from the appliance and
clean filter.
Rinse water is cloudy.
The reason is probably a de-
tergent with a high silicate
content.
No negative effect on the
rinse results; possibly use a
liquid detergent.
When pressing an addi-
tional programme but-
ton, the
correspondingdisplay
does not light up.
The selected additionalpro-
gramme cannot be combined
with the set programme.
Make another selection.
Programme cycledis-
play blinks constantly.
Programme security is
switched On; during the
wash cycle the programme
knob has been moved.
Turn programme knob back
to its original position (see
„Programme security“).
Problem Possible cause Remedy