Operating Instructions

 

 

 

 

 

Problem

Possible Cause

Remedy

 

 

The drain pump for the

 

Turn off the tap, then re-

 

 

washing machine runs

 

 

 

The Aqua Control anti-flood

move the plug from the

 

 

constantly - even when

 

 

the appliance is

system has been activated.

mains and inform Customer

 

 

 

Service.

 

 

switched off.

 

 

 

 

 

 

 

Fabric softener was not

The conditioner insert in the

Clean the detergent dis-

 

 

rinsed in, compart-

compartment for the condi-

 

 

penser drawer and attach the

 

 

ment æ for condition-

tioner is not correctly at-

 

 

conditioner insert securely.

 

 

ers is filled with water.

tached or is blocked.

 

 

 

 

 

 

 

Pay attention to the maxi-

 

 

Washing heavily

Probably too much washing

mum load quantity (see Pro-

 

 

gramme tables). In the case

 

 

creased

put in the drum.

 

 

of easy-care fabrics, select

 

 

 

 

 

 

 

 

the EASY IRON programme.

 

 

 

Drain hose is kinked.

Remove the kink.

 

 

 

 

Contact your local Service

 

 

The washing is not suf-

Maximum pump head (dis-

Force Centre. For pumping

 

 

ficiently spun. Water is

charge height 1m from the

heights over 1m a conver-

 

 

left in the drum.

unit's floor) is exceeded.

sion kit is available as a spe-

 

 

 

cial accessory.

 

 

Error code (2 appears.

 

 

 

 

 

 

 

 

 

Switch off the appliance and

 

 

 

Drain pump blocked.

pull out the mains plug.

 

 

 

 

Clean the drain pump.

 

 

 

The door is locked for safety

Wait until the DOOR/LIGHT

 

 

 

reasons (DOOR/LIGHT display

 

 

The door cannot be

is off).

display lights up green.

 

 

 

 

 

opened when the ap-

 

Cancel programme protec-

 

 

pliance is switched on.

The programme protection

 

 

 

tion (see the section "Pro-

 

 

 

function is set.

 

 

 

gramme protection“).

 

 

 

 

 

 

 

Water tap not fully opened.

Open the water tap fully.

 

 

Remnants of detergent

The inlet hose filter in the

Close the water tap. Unscrew

 

 

are building up in the

 

 

the inlet hose from the water

 

 

detergent drawer.

coupling of the inlet hose at

 

 

tap and the appliance and

 

 

 

the tap is blocked.

 

 

 

clean the filter.

 

 

 

 

 

 

The rinsing water is

The cause is probably a de-

No negative influence on the

 

 

tergent with a high silicate

rinsing results, use a liquid

 

 

cloudy.

 

 

content.

detergent if necessary.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

33

Page 33
Image 33
AEG 88730 manual Turn off the tap, then re