Telephone Operation | AEG C115 manual

tPress the OK button to conﬁrm.

>The third digit of the code will be blinking.

tPress the up or down button to set the third digit of the remote access code.

tPress the OK button to conﬁrm the new remote access code setting.

the stop button to return to standby mode.

8.8TAM HD on/off setting

Two different compression rates (on and off) are provided for you to select the recording quality / total recording time of incoming messages. With the compression rate set to on the recording quality will be higher, but it will only save up to about 20 minutes of messages. With the compression rate set to off the recording quality will be lower, but it will save up to about 40 minutes of messages.

tPress the menu button .

>The display shows “OPTIONS MENU“.

tPress the up or down button until de display shows “TAM HD: ON” (or “TAM HD: OFF”).

tPress the OK button to conﬁrm. >The “ON“ (or “OFF“) will be blinking.

tPress the up or down button to select “ON“ or “OFF“.

tPress the OK button to conﬁrm the TAM HD setting.

9TELEPHONE OPERATION

9.1Ringer volume

The ringer high / low switch located at the back of the base unit, allows you to adjust the volume of the ringer.

High volume

Low volume

9.2To make a call

tLift the handset or press the speakerphone button on the base unit. >Check for dial tone.

tDial the telephone number.

>The display shows the duration of the call in minutes and seconds.

OR Using pre-dialling:
tDial the telephone number.
>If you make a mistake you can correct it by using the delete button	to delete digits and then
adding the right ones.

tLift the handset or press the speakerphone button on the base unit to dial out the number.

9.3To answer a call

tWhen the phone rings, lift the handset or press the speakerphone button on the base unit. >The display shows the duration of the call in minutes and seconds.