Installation and Connection Instructions

3

Special spanner H and cover caps E (2 off) and G (1 off) are supplied

 

with the appliance.

0 1. Remove flexible tubing holder A.

2.Remove the two screws B with special spanner H.

3.Remove the four screws C.

4.Detach transportation rail D.

5.Close the two large openings with the cover caps E.

Attention! Press cover caps forcefully in, so that they snap into the rear wall (protecting the interior of the appliance against sprayed water).

6.Drive in the screws C into the four small holes again.

7.Remove the screw and compression spring F with special spanner H, cover the hole with caps G.

Attention! Press cover caps forcefully in, so that they snap into the rear wall (protecting the interior of the appliance against sprayed water).

Prepare the installation place

The installation surface must be clean and dry, free of floor wax and other smearing substances, so that the appliance does not slip off. Do not use any lubricant as sliding aid.

Installation on a high-veil carpet or floor tiles with soft sponge backs is not recommended because the standing safety of the appliance is then no longer ensured.

By installation surfaces with small-format tiles, lay a conventional rubber mat underneath.

Small unevenness of the floor surface should never be levelled out by laying pieces of wood, carton or similar elements, but rather basically compensated by adjusting the screw feet.

When it is unavoidable to install the appliance besides a gas or a coal-fuelled cooker, due to spatial reasons: insert a piece of heat- insulating board (85 x 57 cm) between the cooker and the washing machine; the board side facing the cooker must be provided with an aluminium foil.

The washing machine may not be installed in a frost-endangered room. Frost-caused damages!

Flexible feed and drain tubings may not be crinkled or squeezed.

33

Page 33
Image 33
AEG W 1020 manual Prepare the installation place