AEG W 1020 Power supply, Water connection

Installation and Connection Instructions

Power supply

Details on the mains voltage,

type of current and the neces-

sary fuse protection are to be

found on the rating plate. The

rating plate is above and

behind the door.

For permanent electrical con-

nection within the electrical

circuit, provisions must be made which allow for electrical disconnec-

tion of the appliance from the mains with a contact opening of at least

3 mm at all poles. Suitable devices include circuit breakers, fuses (thre-

aded fuses must be entirely removed from the socket), ground fault cir-

cuit interrupters and contactors. Permanent connection may only be

carried out by an authorised electrician.

;This appliance conforms to the following EC directives

– "Low-Voltage Directive" 73/23/EWG dated 19 February 1973

and Directive amendment 93/68/EWG

– "EMC Directive" 89/336/EWG dated 3 May 1989

and Directive amendment 93/68/EWG

Water connection

3 The washing machine is provided with safety devices which prevent

reverse pollution of drinking water and conform to the State regula-

tions issued by water supply authorities (e.g. in Germany: DVGW Direc-

tives). Further protective measures in the installation are hence

unnecessary.

Attention! Appliances for cold water connection may not be con-

nected to warm water!

Water pressure must be equal to a least 1 bar (= 10N/cm2 = 0.1 MPa),

and no more than 10 bar (= 100N/cm2 = 1 MPa).

• By more than 10 b ar: connect a pre ssure reduction v alve upstream.

• By less than 1 bar: Unscrew the flexible inlet tubing on the magnetic

inlet valve on one side of the appliance and remove the flow meter

(thereby remove the sieve by means of a pair of pointed pliers and

then remove the rubber washer behind it). Remount the sieve.