AEG W 1020 manual Installation on a concrete base, Installation on vibrating floors

Installation and Connection Instructions

Installation on a concrete base

When installing on a concrete base, for safety reasons it is imperative that steel plates are installed, the washing machine is then installed in these plates. The steel plates are available from customer service under ET-No. 645 425 058.

Installation on vibrating floors

In the case of floors that vibrate, especially wooden floors with floor- boards that flex, a water-proof wooden panel of at least 15 mm thick- ness must be firmly screwed to at least 2 floor beams. If possible, install the appliance in a corner of the room: the wooden floor is more firmly supported in the corners and thus has less tendency to resonant vibra- tion.

Levelling on uneven floors

Using the four adjustable threaded feet, compensation can be made for unevenness in the floor and the height of the appliance adjusted. The height can be adjusted over the range +10... -5 mm.

To adjust the feet use the special spanner supplied for removing the transport braces.

01. Slide the special key firmly onto the hexagon head of the threaded foot all the way to the stop.

2.Adjust the threaded feet so that the appliance is level and sits stably. The appliance must not rock across the corners when operating under load.

3.If necessary, check positioning with a spirit level.

Important! Never compensate for small areas of unevenness in the floor through the use of wooden wedges, cardboard or the like. Level- ling should only ever be performed by adjusting the feet.

34