AeroGarden Ultimate Guide to Caring for Your Pro 100

Basic Reminders About Your AeroGarden (continued)

Raise Lamp Hood (Lights)

As plants grow to 1-2” from lights, raise Lamp Arm one Locking Button at a time. Be sure Lamp Arm is set on the lowest Locking Button when starting your AeroGarden PRO100.

1Unplug AeroGarden PRO100 and remove Bowl from Base.

2Raise Lamp Arm/Lamp Hood by holding Lamp Arm & Hood with one hand, and pushing in Locking Button with the other.

3Replace Bowl on Base and plug in AeroGarden PRO100.

Push Locking

Button in

Replace Grow Bulbs – Order bulbs at www.aerogardensupport.com

When “Replace Grow Bulbs” light on Control Panel begins blinking after 6 months of use…

• Unplug AeroGarden PRO100.

• Remove old Grow Bulbs and carefully discard*.

IMPORTANT: To avoid burning, be sure Grow Bulbs are cool before handling.

• Insert new Grow Bulbs into Lamp Hood.

•Plug in AeroGarden PRO100 and press and release “Reset” button to restart grow bulb timer.

Early Grow Bulb Replacement

If you replace Grow Bulbs before “Replace Grow Bulbs” light illuminates, be sure to restart grow bulb timer as follows:

•Press and hold “Lights” button until white light next to your selected plant type starts blinking – about 5 seconds.

•Release “Lights” button. The plant type selected light will continue to blink for about 9 seconds. While plant light is still blinking…

•Quickly press and release “Reset” button. “Replace Grow Bulbs” light will blink once and the plant selected light will stop blinking.

*Check with local recycling authorities for light bulb recycling availability in your area.

12