Aga Ranges 30AIM manual Troubleshooting Four, Problem, Possible Cause, Correction

Troubleshooting Four

Problem	Possible Cause	Correction
Ice cubes are sticking together.	Ice consumption is low.	Use the ice in the bin frequently. Ice will stick together if left in insulated
		bin over long periods of time.
	Room temperature is too warm.	Move the unit to an area where temperature is below 90 deg. F.
Ice level is too high.	The ice machine is not level.	Use a level to check the unit for level from side to side and front to rear.
	Room temperature is too warm.	Move the unit to an area where temperature is below 90 deg. F.
	Ice deflector is not in place or secured properly.	Check to see that the ice deflector is in place and secured below the
		grid-cutter.
	Bin level sensing tube needs adjusted.	You can adjust the bin level sensing tube by simply pressing directly
		down on the tube 5 inches from the front of the tube to get a desired
		bin level.
Ice level is too low.	The ice machine is not level.	Use a level to check the unit for level from side to side and front to rear.
	Room temperature is too cold.	Move the unit to an area where temperature is above 55 deg. F.
	The selector switch is not in the "ON" position	Set the rocker switch on the grille of the ice machine to the "ON"
		position.
Water keeps backing up into the ice bin	Inadequate drain system.	Restriction or improperly installed drain lines will cause water to back
(gravity drain).		up into the ice bin. Make certain there are no kinks or restrictions in the
		drain lines. If necessary, consult a qualified plumber.
	Foreign material in ice bin drain.	Foreign material is restricting or blocking the ice bin drain located at the
		right rear corner of the ice bin. The drain will need to be cleared.

Water keeps backing up into the ice bin (drain pump).

Drain pump tubing kinked or restricted.	Check inlet, discharge, and vent line tubing for any kinks or restrictions
	and repair as necessary.
Inlet screen to the drain pump is restricted or	Clean the inlet screen to the drain pump.
blocked.
Drain pump and/or the ice machine are not level.	Check and level if necessary the drain pump as well as the ice machine.

The drain pump cycles on and off erratically. Vent line to the drain pump is restricted or kinked.		Check the vent line for any restrictions or kinks and repair as necessary.
	Discharge line is restricted or kinked.	Check the discharge line and connection to the desired drain for any
		restrictions or kinks and repair as necessary.
	The drain pump is not level.	The drain pump must be level. Check for level on the top of the drain
		pump case and adjust the tubing or use shims to level.

All specifications and product design subject to change without notice. 13

Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.