Care and Cleaning
Use & Care Guide
Replacing Light Bulbs
To avoid electrical shock which can cause severe personal injury or death, discon nect power to refrigerator before clean ing. After cleaning, reconnect power.
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before replacing light bulb. After replacing light bulb, reconnect power.
Cleaning the Outside
Circuit breakers must be shut off before cleaning. Using a damp cloth and mild dish- washing detergent, wipe surface lightly. Dry and polish with a clean, soft cloth. Do not wipe panel with a soiled dishcloth or wet towel, these may leave residue that can erode the paint. Do not use scouring pads, powdered cleaners, or bleach because these products can scratch, and/or weaken the paint. Wring excess water from sponge or cloth to avoid excess moisture, especially when cleaning in vicinity of switches, lights or controls.
Removing Odors From
Refrigerator
1.Remove all food and turn the refrigerator OFF.
2.Disconnect power to the refrigerator.
3.Clean the walls, floor, ceiling of cabinet inte- rior, drawers, shelves and gaskets according to the instructions on page 20 and 21.
•Clean condenser coils as indicated in the cleaning instructions every three months. This will increase energy efficiency and cooling per- formance.
To avoid personal injury or property dam age, observe the following:
•Allow light bulb to cool.
•Wear gloves when replacing light bulb.
Fresh Food Section
(style of light shield varies)
1.Slide clear light shield toward back of com partment to release from light assembly.
2.Remove light bulbs.
3.Replace with appliance bulbs no greater than 40 watts.
4.Replace light bulb cover by inserting tabs on light shield into liner holes on each side of light assembly. Slide shield toward front of refrigerator until it locks into place. Do not force shield beyond locking point. Doing so may damage light shield.
20
