Aga Ranges AFHR-36 Touch Temperature Controls, Initial Control Settings, Warm Cabinet Surfaces

Use & Care Guide

2.Remove plastic cap from water valve inlet port.

3.Place brass nut (A) and sleeve (B) on copper tube end as illustrated. Reminder: Do not use an old sleeve.

4.Place end of copper tubing into water valve inlet port. Shape tubing slightly. Do not kink – so that tubing feeds straight into inlet port.

5.Slide brass nut over sleeve and screw nut into inlet port. Tighten nut with wrench. IMPORTANT: Do not overtighten. Cross threading may occur.

6.Pull on tubing to confirm connection is secure. Connect tubing to frame with water tubing clamp (C) and turn on water supply. Check for leaks and correct if necessary. Continue to observe the water supply connection for two to three hours prior to moving the refrigerator to its permanent location.

7.Monitor water connection for 24 hours. Correct leaks, if necessary.

Touch Temperature Controls

The controls are located at the top front of the refrigerator compartment.

Control

Initial Control Settings

After plugging the refrigerator in, set the controls as follows:

•Pressing the or pads adjusts the controls to the desired setting.

•The temperature control range for both compartments is 1 through 7 (coldest).

•Set the freezer control on 4.

•Set the refrigerator control on 4.

•Let the refrigerator run at least 8 to 12 hours before adding food.

Warm Cabinet Surfaces

At times, the front of the refrigerator cabinet may be warm to the touch. This is a normal occurrence that helps prevent moisture from condensing on the cabinet. This condition will be more noticeable when you first start the refrigerator, during hot weather and after exces- sive or lengthy door openings.

Adjusting the Controls

•24 hours after adding food, you may decide that one or both compartments should be colder or warmer. If so, adjust the control(s) as indicated in the Temperature Control Guide table below. See page 17 for instructions on checking compartment temperature.

•Except when starting the refrigerator, do not change either control more than one number at a time.

•Allow 24 hours for temperatures to stabilize.

Temperature Control Guide

Set the refrigerator control Refrigerator too warm to next higher number by

	pressing the		pad.
	Set the refrigerator control
Refrigerator too cold to next lower number by
	pressing the		pad.
	Set the freezer control to
Freezer too warm	next higher number by
	pressing the		pad.
	Set the freezer to next
Freezer to cold	lower number by pressing
	the	pad.
	Press the refrigerator or

Turn refrigerator OFF freezer pad until a dash (-) appears on the dis-

play.

8