Aga Ranges AFHR-36 manual Water Dispenser, Ice and Water, Use & Care Guide

Use & Care Guide

•Certain sounds may accompany the various cycles of the ice maker. The motor may have a slight hum, the cubes will rattle as they fall into an empty storage pan and the water valve may click or “buzz” occasionally.

•If the ice is not used frequently, the ice cubes will become cloudy, shrink, stick together and taste stale. Empty the ice storage bin periodically

and wash it in lukewarm water. Be sure to dry the bin thoroughly before replacing it .

•Beverages and foods should not

be placed in the ice storage bin for quick chilling. These items can block

the sensor arm, causing the ice maker to malfunction.

•Turn off (arm up) the ice maker when the water sup- ply is to be shut off for several hours.

To Remove the Ice Bin:

•Pull it forward, away from the ice maker. To avoid the ice maker dumping ice while the bin is removed, turn the ice maker off by raising the sensor arm.

To Install the Ice Bin:

•Reverse the above procedure. Turn the ice maker on by lowering the sensor arm.

To avoid personal injury or property damage, observe the following:

•Do not place fingers or hands on the automatic ice making mechanism while the refrigerator is plugged in. This will help pro tect you from possible injury. It will also pre vent interference with moving parts of the ejector mechanism and the heating element that releases the cubes.

•Under certain rare circumstances, ice cubes may be discolored, usually appearing with a green-bluish hue. The cause of this unusual discoloration can be a combination of factors such as certain characteristics of local waters, household plumbing and the accumulation of copper salts in an inactive water supply line which feeds the ice maker. Continued consumption of such discolored ice cubes may be injurious to health. If such discoloration is observed, discard the ice cubes and contact your dealer to purchase and install a water line filter.

•Water damage due to improper water connection may cause mold/mildew growth.

•Clean up water and ice spills to avoid person al injury and to prevent mold/mildew growth.

Ice and Water

Water Dispenser

The Water Dispenser is located on the left side wall of the fresh food section. This design is

for cold water dispensing only.

To Dispense Water:

•Hold container under spout and press dispenser pad.

14