Aga Ranges AFHR-36 manual Freezer Features, Ice and Water, Automatic Ice Maker, Lower Wire Basket

	Use & Care Guide
Freezer Features	Ice and Water
	Automatic Ice Maker

To prevent accidental child entrapment or suffocation risk, do not remove the divider in the top freezer basket.

Lower Wire Basket

To Remove:

•Pull open the freezer door to full extension and lift up and out of the door rail to remove.

To Install:

•Lower into door rail. Make sure that the basket sits flush into place. To prevent accidental child entrapment or suffocation risk, do not remove the divider in the freezer basket.

Note

•Energy rating guides that are posted on the refrigerator at the time of purchase do not include optional ice maker energy usage.

Only 36” models come equipped with an automatic ice maker.

Connect the ice maker to the water supply as instructed on page 7. Proper water flow and a level refrigerator

are essential for optimal ice maker performance.

Operating Instructions

•Confirm ice bin is in place and ice maker arm is down.

Upper Wire Basket

To Remove:

•Pull upper basket out to full extension and lift out to remove.

To Install:

•Slide upper basket into freezer. Make sure that rear of basket hooks behind rail catch. To prevent accidental child entrapment or suffocation risk, do not remove the divider in the top freezer basket.

•After freezer section reaches approximately 0° F (-18° C), ice maker fills with water and begins operating. You will have a complete harvest of ice approximately every three hours.

•Allow approximately 24 hours after installation to receive first harvest of ice.

•Discard ice created within first 12 hours of operation to assure system is flushed of impurities.

•Stop ice production by raising ice maker arm until click is heard.

•Ice maker will remain in the off position until arm is pushed down.

•The first one or two batches will probably contain undersized and irregular cubes because of air in the supply line.

•When the ice cubes are ejected it is normal for sever al cubes to be joined together at the ends. They can easily be broken apart. The ice maker will continue to make ice until the supply of ice cubes raises the sen sor arm, shutting the ice maker off .

•If bucket is not positioned properly it may prevent automatic shut-off as ice cubes may not accumulate to raise the sensor arm.

13