Aga Ranges dc6 ELECTRICAL CONNECTION (continued)

ELECTRICAL CONNECTION IS LOCATED AT THE TOP RIGHT HAND SIDE OF THE

APPLIANCE, BEHIND SIDE PANEL. DURING INSTALLATION REMOVE THE RIGHT HAND

SIDE PANELTO CONNECT ELECTRICAL SUPPLY.

Remove 6 screws securing side panel to gain access to mains terminal. See Fig. 3 for location

of cover.

Remember that the mains electrical cable must be routed through the grommet at the rear right

hand side of the cooker near the top via a UL listed strain relief bracket, before connecting to the

mains terminal connection.

REFER TO FIG. 2 & 2Afor wire connection to appliance.

Remember that an excess of cable length is required inside the cooker to allow for possible

servicing of the spark generator, there should be at least 31” (1.22m) of cable from the appliance.

Remember that an excess of cable length is required behind the cooker for the withdrawal of the

cooker from between the kitchen units etc.

Replace the right hand side panel once electrical connection has been made and replace fixing

screws.

NOTE: Ensure the insulation card covering the mains terminal is in place, between the side

panel and mains terminal.

ELECTRICAL CONNECTION (continued)

Fig. 2

Fig. 2A

DESN 514739

DESN 512951