SAM4s ER-5115 Electronic Cash Register Introduction 17
Changing Paper

Loading the Receipt Paper

1. Place the other roll of paper into the small tray on the left.
2. Make sure the paper unrolls from the bottom of the roll.
3. Fold back approximately 6" of paper and insert the folded end of the tape into the feed
slot just in front of the paper tray at the rear of the printer.*
4. Press the RCPT FEED key until the paper comes through the printer. Continue to
press the key until 3 - 4 inches of paper are through the printer.
5. Replace the printer cover, making sure the receipt paper comes out through the opening
in the printer cover.
* Ribbon must be in place when changing paper.
Follow the same steps anytime you need to replace receipt or detail paper. All steps are the same.
However, when replacing detail paper, cut the old detail paper at the spot where the printing stops.
Then use the DETL FEED key to free the old paper from the printer. Remove the old detail paper
from the rewind spindle.