Agilent Technologies 1100 Series

2 Connecting the Hardware

Installing a Network Card in an Agilent Module

Thermo Scientific Agilent 1100 Series LC Devices Connecting the Hardware and Triggering Data Acquisition 5

YTo install the network interface card in an Agilent module

1. Make sure the module (usually the detector) is turned off and unplugged from line

power. Figure 1 shows the location of the power switches.

When the power switch of a module is in the On position, the LED on the switch is

green. When you turn the power switch of a module to the Off position, the LED

turns off.

If your LC stack contains a detector (for example, diode-array detector, variable

wavelength detector, multiple wavelength detector), install the network interface card in

the detector. If your LC stack does not contain a detector, install the network card in any

module with an open slot.

Figure 1. Front panels of the Agilent 1100 Series modules

CAUTION To avoid electric shock, unplug the power cable that connects the Agilent

module to line powe r. After you turn the power switch to the Off position, the power

supply continues to draw current.

Tip You can install an Agilent LAN interface board (model G1369A) instead of a

JetDirect 400N network card.

1100 Series

F2 F3 F4 F5

5 64

1 2 3

0.-

Esc Enter

◄

Detector

Power switch

Column

compartment

Autosampler

Binary pump

Solvent cabinet

Power switch

On position Off position