SM (SMBus) Control
Paddle card Settings
The FS2343 probe is designed so that AMB/LAI device control can be either from the 16900 logic analyzer and the Probe Control application software resident there, or from another FS2343 probe (slave mode).
This feature is controlled by means of a 6 position switch on the probe paddle card near the logic analyzer connections.
The factory configuration is for 16900 control of the probe. The settings on the switch are dependent on the configuration file used. The following picture shows the jumper and switch configurations on the paddle card.
Config file | SW# ON, all others off |
FB238_1 | 1 and 4 |
FB238_2 | 1 and 4 |
FB238_3 | 3 and 6 |
FB238_4 | 1 and 4 |
|
|
Probe Settings
There is a 4 position jumper location at U8 on the top side of the FS2343 Interposer probe. There are jumpers that can be placed over each of the 4 set of pins. They have the following function:
5 | 8 |
|
|
1 | 4 |
|
|
Jumper | Function |
|
|
1 - 5 | Probe ID bit 0 Address 20 |
|
|
2 - 6 | Probe ID bit 1 Address 21 |
|
|
3 - 7 | Jumper removed = AMB SMBus |
| connected to analyzer at powerup. |
| Factory config – installed |
| Jumper installed = AMB SMBus |
| connected to motherboard at power |
| up. |
|
|
4 - 8 | Unused |
|
|
21
