ENGLISH

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)Pliers

(2)7/16" Wrenches

(2)1/2" Wrenches

(2)9/16" Wrenches

REMOVAL OF PARTS FROM CARTON

Removeallpartsandhardwarepackagesfromthecarton.Lay out all parts and hardware and identify using the illustrations on pages 2 and 3.

1.Turn the spreader upside down as shown in figure 1.

2.Remove the lock nut from the middle bolt in the crossover tube and shaft support plate. Leave the bolt in place. See figure 1.

3.Assemble the hitch tube onto the middle bolt and secure it with the same lock nut you removed.DONOTTIGHTEN YET. See figure 1.

IMPORTANT: The hitch tube must attach to the side of the crossover tube opposite the shaft support plate.

4.Assemble the four hitch braces in pairs to the inside of the hopper frame using a 1/4" x 1-3/4" hex bolt (B) and 1/4" nylock hex nut (F) on each side.DO NOTTIGHTEN YET. See figure 2.

5.Assemble the two OUTER hitch braces to the hitch tube using a 1/4" x 1-3/4" (B) hex bolt and a 1/4" nylock hex nut (F). DO NOT TIGHTEN YET. Do not assemble the inner hitch braces at this time. See figure 2.

HITCH TUBE

(B) 1/4" x 1-3/4"

(F) 1/4" NYLOCK

HEX BOLT

HEX NUT

HITCH BRACE

OUTER HITCH BRACE

OUTER

FIGURE 2

SHAFT

SUPPORT

PLATE

CROSSOVER

MIDDLE BOLT

TUBE

HITCH

 

TUBE

 

 

MIDDLE

 

LOCK NUT

FIGURE 1

6.Assemble a spacer (P), a 3/4" flat washer (K), a wheel (air valve facing out) and another 3/4" flat washer (K) onto the end of the axle that has only the small hole. See figure 3.

7.Install a 1/8" x 1-1/2" cotter pin (M) into the hole in the axle. See figure 3.

SMALL HOLE

AIR VALVE

(M) 1/8" x 1-1/2"

COTTER PIN

(P) SPACER

(K) 3/4" FLAT

WASHER

FIGURE 3

5