ENGLISH
17.Assemble the vinyl grip (T) onto the flow control arm. See figure 8.
18.Insert the flow control arm down through the slot in the flow control bracket.Assemble the small hole of the flow control link (U) to the flow control arm using a 1/4" x 1" hex bolt (D), a nylon washer (I) and a 1/4" nylock hex nut (F) as shown in figure 8. Tighten carefully. The flow control link should be snug but should pivot with no more than slight resistance.
(T) VINYL GRIP
OFF
(U) FLOW |
| ON |
CONTROL | 2 | 1 |
LINK | 3 |
|
6 |
| |
| 4 |
|
| 5 |
|
(small hole) | 7 |
|
10 |
| |
| 8 |
|
| 9 |
|
(F) 1/4" NYLOCK
HEX NUT
(I) NYLON 
WASHER
(D) 1/4" x 1" 
HEX BOLT
FIGURE 8
19.Assemble the flow control arm to the flow control mounting bracket using a 1/4" x 1" hex bolt (D), two nylon washers (I) and a 1/4" nylock hex nut (F). Tighten carefully. The flow control arm should be snug but should pivot with no more than slight resistance. See figure 9.
(F)1/4" NYLOCK HEX NUT
ON
2 | 1 |
| |
3 |
|
4 |
|
5 |
|
6 |
|
7 |
|
8 |
|
9 |
|
10
(D) 1/4" x 1"
HEX BOLT
(I)NYLON WASHERS (2)
FIGURE 9
20.Hook the double bent end of the flow control rod through the hole in the slide gate bracket located near the bottom of the hopper. See figure 10.
FIGURE 10
21.Place a 5/16" flat washer (J) onto the other end of the flow control rod. Insert the end of the rod through the curved slot in the flow control mounting bracket and through the hole in the flow control link. Secure with a 5/16" flat washer (J) and a 3/32" x 3/4" cotter pin (L). See figure 11.
NOTE: You can leave off the second washer if there is not enough room on the end of the rod.
|
|
|
|
|
| (J) 5/16" FLAT |
|
|
|
|
| ON | WASHER |
|
|
|
| 2 | 1 |
|
|
|
|
|
|
| |
|
|
|
| 3 |
|
|
8 |
|
| 5 | 4 |
| FLOw |
| 6 |
|
| |||
| 7 |
|
|
|
| |
|
|
|
|
| CONTROL | |
9 |
|
|
|
|
| |
10 |
|
|
|
|
|
|
|
|
|
|
|
| ROD |
(L) 3/32" HAIR
COTTER PIN
(J) 5/16" FLAT
WASHER
FIGURE 11
7