ENGLISH
22.Place the adjustable stop (R) into the "ON" end of the slot in the top of the flow control mounting bracket. Secure with the 1/4" x 3/4" carriage bolt (E), a nylon washer (I), a 5/16" flat washer (J) and the nylon wing nut (Q). See figure 12.
(Q) NYLON |
|
|
|
WING NUT |
|
|
|
(J) 5/16" FLAT |
|
| ON |
WASHER | 4 | 3 | 1 |
|
| 2 |
|
| 5 |
|
|
| 6 |
|
|
(I) NYLON | 7 |
|
|
10 |
|
| |
| 8 |
|
|
| 9 |
|
|
WASHER |
|
|
|
(R) ADJUSTABLE 
STOP
(E) 1/4" x 3/4"
CARRIAGE BOLT
FIGURE 12
23.Position the flow control mounting bracket (figure 13).
a.Push on flow control arm until it locks in "OFF" position.
b.Slide flow control mounting bracket along tube until closure plate in bottom of hopper just closes.
c.Snug the 5/16" nylock hex nuts just enough to hold flow control mounting bracket in place.
d.Set adjustable stop at "5". Pull flow control arm against stop. Verify that closure plate has opened about half way.
e.If closure plate does not open half way, adjust position of flow control mounting bracket until closure plate will open about half way at "5" and will still close when arm is locked in "OFF" position. Tighten the 5/16" nylock hex nuts.
OFFON
FLOw | OFF |
CONTROL |
|
ARM |
|
3 |
|
4 |
|
5 |
|
6 |
|
7 |
|
8 |
|
9 |
|
10 |
|
ADJUSTABLE
STOP
(SETTING "5")
FIGURE 13
8