ENGLISH

CONTENTS

 

SAFETY...........................................................................

4

ASSEMBLY......................................................................

5

OPERATION..................................................................

11

MAINTENANCE ............................................................

11

STORAGE .....................................................................

11

SERVICE AND ADJUSTMENTS...................................

12

TROUBLESHOOTING...................................................

12

REPAIR PARTS .............................................................

22

2.Cut off the plastic tie that holds the height adjustment tube in place.

3.(Figure 2) Assemble the R.H. hitch tube to the sweeper housing using two 5/16" x 1-1/2" carriage bolts (D), 5/16" lock washers (K) and 5/16" hex nuts (H). Do not tighten yet. Repeat for the L.H. hitch tube.

2

ASSEMBLY

 

 

TOOLS REQUIRED FOR ASSEMBLY

 

5/16" x 2"

 

 

 

HEX BOLT (B)

(1)

Knife or Scissors

 

HITCH PIN (Y)

(2)

1/2" Open End or Box End Wrenches

 

 

All loose parts are shown on page 2. Fasteners in the parts

 

HITCH BRACKET

 

(STRAIGHT)

bag are shown full size on page 3.

 

3/4" SPACER (U)

 

 

 

Remove the hardware pack and all loose parts from the

 

HITCH BRACKET

carton and verify that all the parts and fasteners shown on

 

 

 

pages 2 and 3 are included.

5/16" HEX

1/8" HAIR

 

 

 

 

LOCK NUT (G)

 

 

COTTER PIN (N)

 

 

 

ASSEMBLY OF SWEEPER

Note: Right hand (R.H.) and left hand (L.H.) are determined from the operator's position while seated on the tractor.

1.(Figure 1) Assemble the angle bracket to the sweeper housing using a 5/16" x 3/4" hex bolt (F) and a 5/16" hex lock nut (G). Make sure the bracket is turned as shown and aligned straight with the housing and then tighten.

5/16" HEX

1

 

 

LOCKNUT (G)

ANGLE

BRACKET

5/16" x 3/4" HEX BOLT (F)

4.(Figure 3) Fasten the hitch tubes together using two 5/16" x 2-1/2" hex bolts (A), 5/16" small fl at washers (I), 5/16" lock washers (K) and 5/16" hex lock nuts (G).

Do not tighten yet.

3

 

5/16" HEX

 

LOCK NUT (G)

 

5/16" LOCK

 

WASHER (K)

5/16" x 2-1/2"

 

HEX BOLT (A)

5/16" SMALL FLAT

 

WASHER (I)

5