ENGLISH
If your tractor hitch has 11" to 13" ground clearance refer to figure 4. If your tractor hitch has 8" to 11" ground clearance refer to figure 5.
5.(Figure 4 or 5) Assemble the hitch brackets to the hitch tubes using two 5/16" x 2" hex bolts (B) and 5/16" hex lock nuts (G). The bolts should straddle the front hitch tube bolt. Do not tighten yet.
6.At this time tighten the four bolts fastening the hitch tubes to the sweeper housing.Next, tighten the two bolts fastening the ends of the hitch tubes together. Finally, tighten the two bolts fastening the hitch brackets to the hitch tubes.
7.(Figure 4 or 5) Assemble the hitch pin (Y), two 3/4" spacers (U) and the 1/8" hair cotter pin (N) to the hitch brackets.
4
5/16" x 2" HEX BOLT (B)
| HITCH PIN (Y) | |
| HITCH BRACKET | |
| 3/4" SPACER (U) | |
| HITCH BRACKET | |
| (STRAIGHT) | |
5/16" HEX | 1/8" HAIR | |
LOCK NUT (G) | ||
COTTER PIN (N) | ||
|
8.(Figure 6) Assemble the height adjustment handle to the height adjustment tube as shown in fi gure six. Use two curved head bolts (C), bowed washers (L), 5/16" lock washers (K) and 5/16" hex nuts (H).Do not tighten yet.
9.(Figure 6) Assemble the grip onto the height adjustment handle.
| GRIP | 6 |
|
| |
5/16" HEX NUT (H) | HEIGHT |
|
| ADJUSTMENT | |
5/16" LOCK | HANDLE |
|
WASHER (K) |
|
|
BOWED
WASHER (L)
CURVED
HEAD BOLT (C)
10.(Figure 7) Insert a 5/16" x 3/4" hex bolt (F) through the angle bracket. Assemble onto the bolt (in order) the spacer bushing (T), the height adjustment strap, a 5/16" fl at washer (J) and a 5/16" hex lock nut (G). Tighten.
| 5 |
| 7 |
| 5/16" x 2" | 5/16" x 3/4" | 5/16" FLAT |
| HEX BOLT (F) | ||
| WASHER (J) | ||
| HEX BOLT (B) | ||
|
| ||
|
|
| |
| HITCH PIN (Y) | SPACER |
|
| BUSHING (T) | ||
|
| ||
| HITCH BRACKET |
|
|
| (STRAIGHT) |
| 5/16" HEX |
| 3/4" SPACER (U) |
| LOCK NUT (G) |
|
|
| |
| HITCH BRACKET |
|
|
5/16" HEX | 1/8" HAIR |
|
|
LOCK NUT (G) |
|
| |
COTTER PIN (N) |
|
| |
|
|
| |
|
| HEIGHT |
|
|
| ADJUSTMENT |
|
|
| STRAP |
|
6