ENGLISH

5.(Figure 12) Place the assembled lower hopper tubes into the bottom of the hopper bag.

6.(Figure 12) Attach the ends of the lower hopper side tubes to the inside of the upper hopper side tubes using two 3/8" x 1/2" clevis pins (P) inserted from the inside, and two 3/32" hair cotter pins (O).

UPPER HOPPER

12

 

SIDE TUBE

 

3/32" HAIR COTTER PIN (O)

LOWER HOPPER

SIDE TUBE

3/8" x 1/2"

CLEVIS PIN (P)

HOPPER BAG

BOTTOM

7.(Figure 13) Insert the bag frame strap into the stitched sleeve along the front edge of the bag bottom.

8.(Figure 13) Assemble the bag frame strap to the lower hopper side tubes using two 1/4" x 1-1/8" clevis pins

(Q) and 3/32" hair cotter pins (O).

9.(Figure 14) Secure the bag corners around the lower hopper side tubes by snapping the bag fl aps to the bag bottom on both sides.

14

FLAP

SNAP

FIGURE 14

IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the steel rods to loose supporting tension.

10.(Figure 15) Tip the hopper onto it's back to assemble the two hopper support rods. Place the ends of each rod into the upper and lower rear hopper tubes, bending the rod just enough to fi t into the holes in the tubes.

15

13

BAG FRAME STRAP

3/32" HAIR COTTER PIN (O)

1/4" x 1-1/8"

CLEVIS PIN (Q)

SUPPORT

RODS

8