ENGLISH

If your tractor hitch has 11" to 13" ground clearance refer to figure 4. If your tractor hitch has 8" to 11" ground clearance refer to figure 5.

5.(Figure 4 or 5) Assemble the hitch brackets to the hitch tubes using two 5/16" x 2" hex bolts (B) and 5/16" nylock nuts (G). The bolts should straddle the front hitch tube bolt. Do not tighten yet.

6.At this time tighten the four bolts fastening the hitch tubes to the sweeper housing.Next, tighten the two bolts fastening the ends of the hitch tubes together. Finally, tighten the two bolts fastening the hitch brackets to the hitch tubes.

7.(Figure 4 or 5) Assemble the hitch pin (Y), two 3/4" spacers (U) and the 1/8" hair cotter pin (N) to the hitch brackets.

If your tractor hitch has 13" or more ground clearance refer to figure 6, otherwise proceed to figure 7.

8.(Figure 6) Move the rear support brace that came assembled to the rear of the sweeper to the bottom set of holes in the sweeper end plates. This will allow the sweeper bag to sit level when the sweeper is attached to a tractor with a taller hitch.

VIEWED FROM REAR OF SWEEPER

6

5/16" NYLOCK NUT (G)

4

5/16" x 2" HEX BOLT (B)

HITCH PIN (Y)

HITCH BRACKET

3/4" SPACER (U)

HITCH BRACKET (STRAIGHT)

1/8" HAIR COTTER PIN (N)

REAR SUPPORT BRACE

BOTTOM HOLE

9. (Figure 7) Assemble the height adjustment handle to

the height adjustment tube as shown in figure six. Use

two curved head bolts (C), bowed washers (L), 5/16"

lock washers (K) and 5/16" hex nuts (H).Do not tighten

yet.

5/16" NYLOCK NUT (G)

5

5/16" x 2" HEX BOLT (B)

HITCH PIN (Y)

HITCH BRACKET

(STRAIGHT) 3/4" SPACER (U)

HITCH BRACKET

1/8" HAIR COTTER PIN (N)

10. (Figure 7) Assemble the grip onto the height adjustment

handle.

 

GRIP

7

5/16" HEX NUT (H)

HEIGHT

 

 

ADJUSTMENT

 

5/16" LOCK

HANDLE

 

WASHER (K)

BOWED

WASHER (L)

CURVED

HEAD BOLT (C)