ENGLISH

11.(Figure 8) Insert a 5/16" x 3/4" hex bolt (F) through the angle bracket. Assemble onto the bolt (in order) the spacer bushing (T), the height adjustment strap, a 5/16" flat washer (J) and a 5/16" nylock nut (G). Tighten.

5/16" x 3/4"

5/16" FLAT

8

HEX BOLT (F)

 

 

WASHER (J)

 

SPACER

BUSHING (T)

5/16" NYLOCK NUT (G)

ASSEMBLY OF HOPPER BAG

1.(Figure 10) Turn a rear hopper tube so that the brace holes in the middle of the tube face down.

10

REAR HOPPER TUBE (brace holes on bottom)

HEIGHT ADJUSTMENT STRAP

12.(Figure 9) Position the height adjustment handle side to side so that the tooth lock washer (M) can fit between the handle and the height adjustment strap. Tighten the nuts securing the height adjustment handle.

13.(Figure 9) Insert the 5/16" x 1" carriage bolt (E) through the height adjustment handle. Assemble onto the bolt, in order, the 5/16" tooth-lock washer (M), the height adjustment strap, a 5/16" flat washer (J) and the plastic knob.

5/16" FLAT

9

 

WASHER (J)

PLASTIC

5/16" x 1"

KNOB

CARRIAGE BOLT (E)

 

2.(Figure 11) Insert the two upper hopper side tubes through the stitched flaps on each side of the hopper bag.

3.(Figure 11) Assemble the ends of the rear hopper tube onto the ends of the upper hopper side tubes. Fasten together using plastic plugs (Z).

PLASTIC PLUG (Z)

11

UPPER HOPPER

 

SIDE TUBE

 

TOOTH LOCK WASHER (M)