ASSEMBLING CART COVER

1.Slide the front support tube through the double loops located near the front of the cart cover. See figure 19.

DOUBLE LOOPS

FRONT

 

SUPPORT

 

TUBE

CART COVER

FIGURE 19

2.Slide two of the lower support rods through the center loops located in the top of the cart cover as shown in figure 20.

CENTER LOOP

CENTER LOOP

SUPPORT

 

RODS

CART COVER

 

FIGURE 20

3.Slide the last lower support rod through outer edge of the cart cover. The bend in the rod must face in the direction shown in figure 21.

CART COVER

SUPPORT ROD

BEND

FIGURE 21

PERFORM STEPS 4-6 IF YOU ARE USING SPRAY ADHESIVE (RECOMMENDED). IFYOU ARE NOT USING SPRAY ADHESIVE, SKIP TO STEP 7 ON PAGE 12.

4.Apply spray adhesive to the side of the top support angle shown in grey. Follow directions on spray adhesive for proper application. See figure 22.

5.Once the spray adhesive is tacky to touch, place top support angle inside of cart cover and fold the edges of the cover onto side of support angle with spray adhesive.

See figure 22.

6.Wait until adhesive dries, securing support angle in place, before continuing to step 7.

TOP SUPPORT

ANGLE

CART

SPRAY

BAG

ADHESIVE

 

 

FOLD EDGES

FIGURE 22

11