13.Insert the latch lock lever into the rear tongue as shown in figure 8A. Secure it in place using the 5/16" x 4" hex bolt and 5/16" nylock nut.

14.Attach the spring to the hole in the rear tongue and the lower hole in the latch lock lever as shown in figure 8B.

A

LATCH

 

LOCK

5/16" LOCK NUT

LEVER

 

5/16" x 4"

HEX BOLT

B

SPRING

FIGURE 8

15.To prevent accidental tipping during the following assembly procedures, lower the cart to rest upside down on its top flanges, so that the wheel support is facing up. See figure 9.

16.Lay the drawbar tongue onto the Wheel Support and the Latch Stand Bracket. Assemble the axle through the wheel support and the tongue. See figure 9.

AXLE

REAR

TONGUE

LATCH STAND

BRACKET

FIGURE 9

IMPORTANT: Make sure drawbar tongue is securely locked to the latch stand bracket by the latch lock lever.

17.Assemble a flat washer, a wheel with the valve stem facing out, another flat washer and an axle clip onto the axle as shown in figure 10. Secure the wheel on the axle with a cotter pin, spreading the ends. Repeat on other end of axle.

WHEELAXLE

FLAT

WASHER

AXLE

CLIP

FLAT

WASHER

COTTER PIN

FIGURE 10

18.Assemble the hitch bracket to the front tongue using two 3/8" x 1" hex bolts and 3/8" nylock nuts. See figure 11.

TONGUE

(FRONT) 3/8" x 1"

HEX BOLT

HITCH

BRACKET

3/8" NYLOCK NUT

FIGURE 11

8