9.Assemble the front panel over the opposite end of the cart using four 1/4" x 3/4" hex bolts and 1/4" nylock nuts as shown in figure 4. Leave two holes open in the bottom of the panel as shown in figure 4. With the cart body halves pulled together, tighten the two bolts in the bottom of the front panel, then tighten the bolt in each side.
At this time tighten the two bolts on the bottom of the cart which were assembled in step 4.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET 1/4" x 3/4"
HEX BOLT
1/4" NYLOCK NUT
1/4" NYLOCK NUT
1/4" x 3/4"
HEX BOLT
FIGURE 4
11.Turn the latch stand bracket so that the aligning tab is at the rear (bottom) of the bracket. Assemble the latch stand bracket to the cart using four 1/4" x 3/4" hex bolts and 1/4" nylock nuts. Tighten. See figure 6.
LATCH STAND BRACKET
1/4" x 3/4"
HEX BOLT
ALIGNING TAB AT BOTTOM
1/4" HEX NUT
FIGURE 6
10.Assemble the wheel support to the cart using eight
5/16" x 3/4" truss head bolts and 5/16" nylock nuts as shown in figure 5. Heads of bolts go on the inside of cart. Tighten.
5/16" x 3/4"
TRUSS HEAD BOLT
WHEEL
SUPPORT
5/16" 
NYLOCK
NUT
12.Assemble two 1/4" x 3/4" hex bolts and 1/4" nylock nuts to the two rear corners of the cart. Tighten. See figure 7.
1/4" x 3/4" |
|
HEX BOLT | 1/4" NYLOCK |
| |
| NUT |
FIGURE 5 | FIGURE 7 |
7